0
Posted June 6, 2013 by Sean Blackmore in Lawn-Garden
 
 

Repairing a damaged mailbox starts with setting the post



There are about 52 million curbside mailboxes in the United States, according to the United States Postal Service. Regrettably, many of these mailboxes face harm caused by inclement climate, inattentive drivers or other unexpected incidents that can make mail delivery far more difficult. While it is unrealistic to consider all dangerous accidents to mailboxes can be prevented, homeowners can lessen the time a damaged mailbox is out of commission by producing the essential repairs in a timely manner.

There are numerous fun and creative ways to spruce up a broken down mailbox with brick, stone, paint, stain and other artistic components, but it all starts by securing the mailbox post firmly in the ground. With no a properly-grounded post, the decorative or aesthetic worth of a mailbox could be quick-lived. Quikrete Rapidly-Setting Concrete Mix doesn&rsquot require any mixing and reaches a strength of four,000 pounds per square inch in two hours, making it a well-liked material for setting a selection of posts which includes mailboxes, fences and basketball targets.&nbsp

Methods for setting a post

When operating with cement-based items, usually put on eye protection and waterproof gloves.

* Dig a hole that is three occasions the width of the post and one-third to a half the length of the post, and pour six inches of all-objective gravel into the bottom of the hole.
* Put the post into the hole and attach 2-by-4 wood braces to the adjacent sides of the post ahead of making use of a level to position the post completely vertical.
* Fill the hole with Quikrete Quick-Setting Concrete Mix within 3 to 4 inches from the prime of the hole.
* Pour up to a single gallon of water into the hole until is soaks into the dry concrete mix and permit the concrete to set for 20 to 40 minutes.
* Wait four hours ahead of putting a mailbox or other heavy objects on the post.

The same quickly-setting material can also be used to pour sidewalks, patios, driveways and other concrete surfaces that home owners anticipate experiencing pedestrian or vehicle targeted traffic rapidly.

Pouring a concrete slab

* Construct a type from two-by-four lumber, spot and compact three to four inches of gravel inside the type as a base, and dampen the form and gravel.
* Spot the advisable amount of water into the mixer and then progressively add the concrete mix into the mixer with the water till it is the appropriate consistency. Do not mix much more concrete than can be placed in ten minutes.
* Pour the concrete mix evenly into the type until it is two to three inches above the leading of the form.
* Strike off excess concrete utilizing the screed board back, float the surface with a trowel and apply non-slick broom finish.
* Take away the type from the concrete slab using an edger and wait 4 hours just before placing any heavy objects or allowing foot traffic.

For much more data, products, tips and how-to videos on setting a mailbox post and other residence improvement projects, go to www.quikrete.com, like on Facebook comply with on Twitter.

QR Code – Take this post Mobile!
Use this unique QR (Quick Response) code with your smart device. The code will save the url of this webpage to the device for mobile sharing and storage.

Sean Blackmore

 
avatar